www.86garage.com

tired of waiting for money to finish my silver top swap looking for a good condition 16v i have almost everything for the swap just need the wiring conversion i drilled the back of the head also need to get that welded to block the back water lines i have the 20v wire hardness ecu inlet and outlet water lines done new cap and rotor timing belt head gasket live in houston area thanks

Ive got a rebuilt block laying around and Im interested. Shoot me a PM.

EDIT: Rebuilt tall block.


Supposedly 2000 miles before the car it was in was side-swipped.

i have a blown 16 in my car right now with full rebuild kit( new water, oil pump, piston head/ring, full gasket set, timing belt, bearings, ect.)

I wish I had a motor just laying around lol! That a 3 rib mex? Finally got your message btw. My phone seems to be taking a dump on me.

My motor has 200k miles on it. I bought it so that if this one dies i have another one ready to go with minimal downtime (the corolla is my ONLY car!). I dont know if its a 3-rib or a 7-rib but if I had to bet I would imagine its a 3-rib.

I also have two other engines laying around in addition to this one, but i figure they are junk. Aaron got the head off of one and the other is just sitting there.

mexellent wrote:Ive got a rebuilt block laying around and Im interested. Shoot me a PM.

EDIT: Rebuilt long block.

Supposedly 2000 miles before the car it was in was side-swipped.

And I believe the place that rebuilt it is called Just Japan but I could be mistaken. And the car it was in was T-Boned after a week or two on the new motor.

AE86silverred wrote:tired of waiting for money to finish my silver top swap looking for a good condition 16v i have almost everything for the swap just need the wiring conversion i drilled the back of the head also need to get that welded to block the back water lines i have the 20v wire hardness ecu inlet and outlet water lines done new cap and rotor timing belt head gasket live in houston area thanks

PM'd.

sorry i was out of town with no computer. landslide what you mean a blown 16 valve like i dosent work? or turboed

AE86silverred wrote:sorry i was out of town with no computer. landslide what you mean a blown 16 valve like i dosent work? or turboed

lol. i wish it was turbo. its a 16 v with a blown head gasket. i have the full rebuild just no place to do it, or tools, or knowledge of rebuilding a motor. i have plenty of time though.

hay whats a 3-rib or 7 rig and which one is better?

7 rib is better its the strangth of the block casting lol...
you can count the ribs on the side of the block ...

think of them of being beams a 3 beam or 7 beam lol..

cool thanks