Page 1 of 3
~~~ 4A-GE Short Block + Goodies ~~~
Posted: Mon Oct 05, 2009 9:00 pm
by CBR_TOY
i have for sale a bluetop short block that is need of a rebuild. this bottom end had around 200k on it before being replaced
it is a block with rods/pistons/crank still installed but that's it
also included are a used set of bluetop piston/rods mileage unknown with bearings
this will also come with brand new-
*ARP rod bolts
*stock size rings
*maybe some other stuff but gotta look
PERFECT FOR REBUILD
$175 for the lot!
Posted: Mon Oct 05, 2009 11:53 pm
by landslideATX
price/pics
Posted: Mon Oct 05, 2009 11:58 pm
by gda03subaru
agreed with landslide, and daniel you have dibs on anything i have left over, i have 2 blocks now and some other stuff, i got your skateboard riding back
Posted: Tue Oct 06, 2009 12:18 am
by dr.occa
i vouch for the block.
no spun bearings, etc. just a refresher (remove excess casting material, nice droid oil bath a la C-3PO, new freeze plugs, hone, fresh set of bearings and rings) or you could just try replacing the rings alone but you're going to crack it apart anyway just to do that so might as well give her a new lease on life.
hope it goes to a good home. i'd love to pick it up but i'm over committed and spread thin at the moment. i WILL be picking up 1 or 2 plants in the near future (if the Almighty wills it that is).
Posted: Thu Oct 08, 2009 10:11 am
by CBR_TOY
standard size rings.....
ARP rod bolts....
and the piston/rod assembly.....
Posted: Thu Oct 08, 2009 3:52 pm
by gda03subaru
not to shabby, wish i was close by, i wish you would sell me the studs seperatly since those could be shipped
Posted: Thu Oct 08, 2009 9:33 pm
by landslideATX
i may have the money very soon i hope. i've been working 12 hour days. i just have to get paid now.
Posted: Thu Oct 08, 2009 9:53 pm
by gda03subaru
thought you just needed a head gasket to get rolling again?
landslideATX wrote:i may have the money very soon i hope. i've been working 12 hour days. i just have to get paid now.
Posted: Fri Oct 09, 2009 8:30 am
by landslideATX
well i have a full rebuild kit. but might as well pick up something that i can build and then drop in. also wouldn't hurt to have extra parts. the rebuild doesn't come with connecting rods or arp head studs. i haven't taken it apart yet to check the rods.
Posted: Fri Oct 09, 2009 8:43 am
by CBR_TOY
well then this would be perfect... just let me know
Posted: Mon Oct 12, 2009 8:13 am
by CBR_TOY
bump for cheap parts
Posted: Mon Oct 12, 2009 4:24 pm
by gda03subaru
post some pics of the motor bump
Posted: Mon Oct 12, 2009 6:05 pm
by CBR_TOY
will do....
Posted: Sun Oct 18, 2009 9:51 pm
by landslideATX
still have this? i pm'd you.
Posted: Fri Oct 23, 2009 7:41 pm
by CBR_TOY
obo.... just need it gone