www.86garage.com

Just like the title says. I have a set of open diff Zenki axles and the center section for the diff from the same rear end. I would recommend changing out the bearings. The rear end was whining, but I think one of the wheel bearings or carrier bearings were bad. The R&P seem to be in good shape. The axle that was on the passanger side is only 4 years old. I bought a new one from toyota right after I bought the car back in 2004/2005. I also put a new wheel bearing on that side, but it could have gone bad. I'm not sure. I'll post some photos up tonight. I'm at work right now but I wanted to post this up.

I'm asking $120 O.B.O. for the axles and $60 for the pumpkin, R&P (whole center section). Just get in touch with me. I'll have pictures up tonight.

Pics of the axles and diff...I know the diff pics aren't the best. I was battling waning light in the garage. I'll try again tomorrow if I can get some sunlight...but it may rain tomorrow so we'll see.

The axle on the left is the new of the two that was bought in 2004/2005 from Toyota and had a new wheel bearing installed at the same time.

I just took some quick measurements. The newer axle is roughly 7mm smaller than the (from what I know) original axle that was on the driver-side. I'm assuming this means that I have 1 zenki lsd axle and 1 zenki open diff axle. I know I had them installed on my open diff vehicle for almost 4.5-5 years.

LSD axles are 0.256" shorter than non-LSD

I'll take some more accurate measurements tomorrow. From what I measured tonight, I was getting just above 7mm difference between the two (around 5-7/16" difference). So it looks like Cavender Toyota may have gotten the order wrong, even with the vin. Doesn't surprise me.

If this is truly the case:

$60 for the open diff axle
$80 for the LSD axle

I'll take some measurements after work tomorrow to verify.

Mike,

I may be interested in that open diff pumpkin.

Okay, just let me know. You still have my number? I'm at work until 5PM every day and I get home around 5:30-6PM. Free on the weekends still. You're more than welcome to stop by and take a look at it.

do you still have the axles?

uneektony wrote:do you still have the axles?

Please check the dates this thread is 30 months old....if your not sure pm the person

wait the zenki lsd axle steps down 3 times or two?

bt20v wrote:

uneektony wrote:do you still have the axles?

Please check the dates this thread is 30 months old....if your not sure pm the person

wow didn't even check the date @_@

Would this even fit a zenki GTS housing?