www.86garage.com

4age stock internals
milled clyinder head with a valve job
the piston rings looks to be siezed up
$150 obo







2nd 4age
the cons
it needs new pistons because of an improper fuel/air mixture and too advance timing

the pros
its a blue top with red top internals
the connection rods and everything else looks to be good
the cylinder heads have a port and a 3 angle valve job done
New HKS head gasket
the block has been bored over by .02
will come with what's left of the gasket set.(the other gaskets are on the engine)
nst crank pully
it has a high pressure oil pump
wiring harness, maf sensor etc..
intake manifold, exhaust manifold etc...
alternator
everything that it will need to run except for tranny, tranny will cost an extra 250.
i'm not sure of the mileage on this one either it from my friend too it came from a trade i did
with him.









lot more stuff but i don't have the pics for everything.
this one for $300 obo

Where are you located? Sorry if its up here somewhere, just didn't see it.

^ +1

Where are you located?

Motor is sold to me

Donnie25 wrote:Motor is sold to me

That's all good, kinda just want a head anyhow, but I'd still like to know where it is.. I got the money for you, just need to work out shipping

Which motor was sold?

cdixon311 wrote:Which motor was sold?

Both, I have them both

Dang, guess this thread was abandoned