www.86garage.com

curious if anyone would be interested in a bolt in f20 swap for there 86

swap would include


darton sleeves
carrillo a beam rods
cp 11 to 1 pistons
rod and main bearings have 5 events on them
brian crower dual titanium valve springs
brian crower valve keeper locks
brian crower stainless steel intake and exhaust valves
arp head studs
cosworth 1.1 mm head gasket
t3 flange turbo manifold with a two bolt tial 38 mm wastegate flange
1000 cc fic injectors
fuel rail with -6 inlet and outlet
stock 6 speed trans
jsp fab ae86 to f20 swap kit
rue map delete
rue egr delete
water pump
alternator
2 piece drive shaft for 86 to f20
stock uncut harness and ecu
stock clutch and fly wheel

5k obo get at me!

forgot to add

notched 86 crossmember for f20 oil pan
oil pan tapped for - 10 turbo oil drain
can include stock oil pan if needed
-3 oil feed line for turbo

this sounds good.... glws

Someone buy my kidney.

c4ptiv3 wrote:Someone buy my kidney.

hahah

Will do you have more street/daily f20 drop in setup?

This motor is just a upgraded stock motor same displacment, compression, and cams i can give you stock injectors and manifold if you want

Do you have any extra F20 swap parts?

you are going to have to be more specific

I need the Mounts and Drive shaft.

i have that stuff but want to sell it all as a package. I know 5 k sounds like a lot but you will be hard pressed to swap a stock f20 into your car for less

5k is actually a really good deal! but I already have the engine, tranny, harness, etc just missing those parts to complete the swap. Im about 2k into the build with parts so far.

PM'd, still interested!