Page 1 of 1
looking for a engine mech....
Posted: Thu Mar 11, 2010 1:41 am
by fmedina
pretty much wanted to know if someone could do a engine rebuild for me, of course i'll pay you for the work... and parts and what not, nothing special just a simple engine overhaul...
Re: looking for a engine mech....
Posted: Thu Mar 11, 2010 11:32 pm
by dr.occa
just the bottom end or both bottom end and head.
most techs here don't have all the machinery to do it in house. heads and blocks are usually sent of to machine shops. blocks are usually assembled at the machine shop they're sent to along with the bearings if it's just a rebuild. full build up the rods, pistons, pins rings and mains, rods & thrust bearings. crank usually turned.
head just sent off for a good cleaning and either assembled at machine shop or back at the shop with stock parts or your cams, rocker arms/buckets and springs of choice.
either way, you may consider this info regarding your block build/re-build investment.
Re: looking for a engine mech....
Posted: Fri Mar 12, 2010 2:06 pm
by nt66
I can do this for you at the shop. I mic everything out to make sure no machine work is needed and put it together.