ITB from motorcycle
Posted: Tue May 19, 2009 12:13 pm
Page 1 of 1
Posted: Tue May 19, 2009 12:50 pm
RC51 has 48mm's.... and those fit nicely on that ford motor
Posted: Tue May 19, 2009 1:44 pm
cool page.
i've got the following:
Make/Model: GSXR 1000
Year: -02
Number of Tb: 2
Inside Diameter: 42mm
Center-Center (left to right from behind): 80-80-80mm
Overall Length:
Outside Diameter (intake):
Outside Diameter (filter):
Separate casting: No (dual Tb´s)
Injector Make/Model: Keihin,
Flow Rate (45psi/100%): 230cc/min
Fuel Rail Inside Diameter:
Additional Info: sec. throttles controlled by ECU.
Make/Model: GSXR 600
Year: -02
Number of Tb: 4
Inside Diameter: 38mm
Center-Center (left to right from behind): 80-80-80mm
Overall Length: 83mm
Outside Diameter (intake): 44mm
Outside Diameter (filter): 45mm
Separate casting: Yes
Injector Make/Model: Keihin KN4, 0J07 AAA A <---???(mine are MIKUNIS though)
Flow Rate (45psi/100%): 240cc/min?, 13Ω
Fuel Rail: Alu casted, Inside diameter 6mm (9mm in the ends)
Additional Info: sec. throttles controlled by ECU.
i've got the following:
Make/Model: GSXR 1000
Year: -02
Number of Tb: 2
Inside Diameter: 42mm
Center-Center (left to right from behind): 80-80-80mm
Overall Length:
Outside Diameter (intake):
Outside Diameter (filter):
Separate casting: No (dual Tb´s)
Injector Make/Model: Keihin,
Flow Rate (45psi/100%): 230cc/min
Fuel Rail Inside Diameter:
Additional Info: sec. throttles controlled by ECU.
Make/Model: GSXR 600
Year: -02
Number of Tb: 4
Inside Diameter: 38mm
Center-Center (left to right from behind): 80-80-80mm
Overall Length: 83mm
Outside Diameter (intake): 44mm
Outside Diameter (filter): 45mm
Separate casting: Yes
Injector Make/Model: Keihin KN4, 0J07 AAA A <---???(mine are MIKUNIS though)
Flow Rate (45psi/100%): 240cc/min?, 13Ω
Fuel Rail: Alu casted, Inside diameter 6mm (9mm in the ends)
Additional Info: sec. throttles controlled by ECU.
Posted: Tue May 19, 2009 2:06 pm
you're not cool....
Posted: Tue May 19, 2009 2:20 pm
CBR_TOY wrote:you're not cool....
well, not yet anyway. when they're on the engine i will be...:D
Posted: Tue May 19, 2009 2:22 pm
awesome iv seen this page. i want to try something like this in the future.
i just need money time and an ecu
i just need money time and an ecu
Posted: Tue May 19, 2009 2:24 pm
is this what that piece is for you're waiting on me to make?
Posted: Tue May 19, 2009 2:55 pm
maaaaaaaaaaybe...CBR_TOY wrote:is this what that piece is for you're waiting on me to make?
