austin/s.a. people going to the meet...

landslideATX · Post by **landslideATX** » Thu May 14, 2009 10:00 pm

CBR_TOY wrote:i know i need to do mine here soon.....

we should have a bearing party. any one els need to change out theres?

inertia · Post by **inertia** » Thu May 14, 2009 11:29 pm

dr.occa wrote:
landslideATX wrote:don't need any special tools?
-floor jack
-jack stand
-rubber mallet
-flat head screwdriver
-17mm or 19mm socket/crow's foot
-pliers
-high temp bearing grease
-rags

and the bearing lol cant swap them if you dont have them

Post by **dr.occa** » Fri May 15, 2009 6:26 am

landslideATX wrote:
CBR_TOY wrote:i know i need to do mine here soon.....
we should have a bearing party. any one els need to change out theres?

if you believe you can make it to houston safely w/ what you currently have, we may be able to swap out your bearings along w/ CBR's.

Post by **CBR_TOY** » Fri May 15, 2009 8:19 am

i'm gonna do the event and demo then rip the car apart.... so no bearings just yet

ga_goosh · Post by **ga_goosh** » Fri May 15, 2009 10:10 am

i need to change my rear wheel bearings but i dont know if it is a weekend job or not

landslideATX · Post by **landslideATX** » Sat May 16, 2009 5:05 pm

ga_goosh wrote:i need to change my rear wheel bearings but i dont know if it is a weekend job or not

i need to put my diff in. i don't have a slide hammer though.

Projectgofast · Post by **Projectgofast** » Sat May 16, 2009 8:57 pm

You can borrow one from auto zone

Post by **dr.occa** » Sat May 16, 2009 10:04 pm

Projectgofast wrote:You can borrow one from auto zone

yes, you go, now.

ga_goosh · Post by **ga_goosh** » Sun May 17, 2009 4:37 pm

hmmm...they do rent these out...

landslideATX · Post by **landslideATX** » Sun May 17, 2009 5:15 pm

i know advanced does. my friend works there. i just don't want to happend what happend last time i tried to take apart a rear end on an 86. i went thru two slide hammers from harbor freight.