So Im pretty sure my head gasket popped on me

cdixon311 · Post by **cdixon311** » Sun Jul 03, 2011 3:33 pm

Good luck

bt20v · Post by **bt20v** » Wed Jul 06, 2011 9:15 am

motors almost back together been taking some photos and will upload them to photo site and start my build thread soon. I had pitting under the fire ring under number 4 on the block side so they had to take .05 off the block. everything looked to be stock original. Standard bearings and rings went back in. Maybe it will be running in the next 2 weeks.

Post by **dr.occa** » Wed Jul 06, 2011 12:47 pm

bt20v wrote:motors almost back together been taking some photos and will upload them to photo site and start my build thread soon. I had pitting under the fire ring under number 4 on the block side so they had to take .05 off the block. everything looked to be stock original. Standard bearings and rings went back in. Maybe it will be running in the next 2 weeks.

Good to hear JL

bt20v · Post by **bt20v** » Wed Jul 06, 2011 2:02 pm

yea its time consuming when you clean and paint everything just about that you take off the motor.

McKenney · Post by **McKenney** » Fri Jul 08, 2011 3:42 pm

BUT OH SO WORTH IT! I'm admittedly jealous how clean his is looking now as it's coming back together.

bt20v · Post by **bt20v** » Wed Jul 20, 2011 11:24 am

ok so drove the car for the first time in a couple months.WOO HOO..I still have a high clutch pedel whcih i hate (any ideas)

www.86garage.com

So Im pretty sure my head gasket popped on me

Re: So Im pretty sure my head gasket popped on me

Re: So Im pretty sure my head gasket popped on me

Re: So Im pretty sure my head gasket popped on me

Re: So Im pretty sure my head gasket popped on me

Re: So Im pretty sure my head gasket popped on me

Re: So Im pretty sure my head gasket popped on me