www.86garage.com

Bought the KSD engineering IACV block off plate and have a few questions relating the electronics/vacuum lines that would normally plug into the IACV. Sorry in advance for the sizes of the images.


On this valve on the air filter box should i leave this plug connected to the engine harness and should I cap or run hoses anywhere on whatever that is underneath the plug? usually it ran to the IACV.



The plug in this picture plugged into the part in the 2nd picture below, what should I do with it?






and is there anything else I need to do now that the plate is on?

lol, yeah that was my fault. I didn't see the resize option til after the post. I'll try to go in and edit them later.

dr.occa wrote:

"Holy huge pictures Batman!"

[really] hahaha