Re: My 4ac is missing/sputtering?
Posted: Fri Jul 19, 2013 4:18 pm
So i adjusted the air fuel, and the popping is gone form idle. vacuum reads at 18, still a slightly shaky needle, but doesn't deviate from 18.
at 2k-3k rpms, its still there. I noticed something today. The haynes manual says to check the centrifugal advance on the distributor, pull it clockwise, and it will return to its normal settings. I did so, and my doesn't return back at all. Could be the cause of my problems. Now either take it apart, or just replace the whole thing.
at 2k-3k rpms, its still there. I noticed something today. The haynes manual says to check the centrifugal advance on the distributor, pull it clockwise, and it will return to its normal settings. I did so, and my doesn't return back at all. Could be the cause of my problems. Now either take it apart, or just replace the whole thing.