Page 3 of 3
Posted: Wed Jul 15, 2009 8:29 am
by Munki
dr.occa wrote:the throw out bearing doesn't look that bad. i've come across way worse.
you could have kept the transfer case on the gearbox if you were going to just clean it. but the trans looks quite clean. good job on that.
oh, and what is that silver, metal dragon's neck looking thing coming from the distributor area to the front of the bay?
Well, I bought all new paper gaskets.
And the throw out bearing looks alot worse in person, it doesn't even spin free.
Posted: Fri Jul 17, 2009 7:52 pm
by Munki
today I finished installing the trans. and now it wont go into gear... As I was bolting on the slave I noticed the clutch fork would only move back and not forward. And also, the tip of the slave the hits the fork is put into the slave alittle. Any one know what the problem is?? I need to get this car running asap, its my only car...
EDIT::
Nevermind, It shifts perfect now. The car drives so much better and now I can go to some drift events!!
Posted: Wed Jul 29, 2009 4:35 pm
by raiste
dr.occa wrote:...
oh, and what is that silver, metal dragon's neck looking thing coming from the distributor area to the front of the bay?
Munki wrote:
Looks like an A/C line?
.
Posted: Wed Jul 29, 2009 8:59 pm
by Munki
lol, yeah its a AC line