Page 1 of 1
do i need this
Posted: Sat Nov 21, 2009 7:28 pm
by landslideATX
i lost the bolts for it and haven't found them yet. but i was wondering if i need this or if i can just cap it off.
Posted: Sat Nov 21, 2009 7:57 pm
by nt66
in my opinion you need it to promote proper coolant flow through the head
Posted: Sat Nov 21, 2009 8:05 pm
by landslideATX
thats what i thought. just wasn't sure. someone said it might be for the heater. do you know the size of the bolt so i can replace them and get her running?
Posted: Sat Nov 21, 2009 10:45 pm
by CBR_TOY
i would just sell it to me for cheap if i were you :D
Posted: Sun Nov 22, 2009 12:17 am
by landslideATX
p.s. thats not my motor in the pic. it was pulled off the web for referance.
.
Posted: Sun Nov 22, 2009 6:23 pm
by 85levin
if you don't need any of the sensors or a heater you can cap it off. you are also going to need to cap off the other side of the hose, it is on the back side of the water pump housing on the rwd 4ag next to the thermostat, unsure about the fwd. did it to my old 16v
bolt size is m6X1.0 length should be about 35-40mm check with a piece of wire then measure it.
hope that helps
Posted: Sun Nov 22, 2009 7:54 pm
by mooreofit
those are thermostatic switches for the egr by the way.
Posted: Sun Nov 22, 2009 10:54 pm
by landslideATX
Thanks guys. yeah, i'm putting everything back together and taking off the egr stuff.