Page 1 of 1
need a 60-2 wheel mated to a 3tc crank pulley, suggestions?
Posted: Thu Dec 24, 2009 8:51 am
by oneslowaw11
I am getting everything ready for my ems and need to find somewhere that can mate the trigerwheel to my crank pulley. we dont have crap around here and I wouldnt even know who does good work around here. I would be willing to ship the 2 out to have done.
Re: need a 60-2 wheel mated to a 3tc crank pulley, suggestions?
Posted: Thu Dec 24, 2009 1:16 pm
by 85levin
just center it up yourself and take it to a good welder. doesn't need to have automotive experience.
Re: need a 60-2 wheel mated to a 3tc crank pulley, suggestions?
Posted: Thu Dec 24, 2009 1:25 pm
by oneslowaw11
you need a max of .003 runout between the sensor and pulley at all times when the wheel is mated. I would rather have it done by someone with experience. I know there are some around here running electromotive, motech and haltech ems and was wondering who did theres
Re: need a 60-2 wheel mated to a 3tc crank pulley, suggestions?
Posted: Thu Dec 24, 2009 1:45 pm
by dr.occa
i recommend sending your pulley and trigger wheel to NST. they outfitted my crank (nst pulley) with a 36-1 wheel from a contour that i provided. perfectly executed.
Re: need a 60-2 wheel mated to a 3tc crank pulley, suggestions?
Posted: Fri Dec 25, 2009 9:31 am
by mooreofit
nst ftw!