Page 1 of 1
tension rod
Posted: Fri Feb 01, 2008 9:44 pm
by landslideATX
as most of you know i recently ran my car into a curb. messing up the lower control arm and the tie rod. got that fixed. now i have a problem with the tension rod. the two bolts that go up into the lower control arm, one of them is in but the one closest to the front is off by like a quarter of an inch. will this effect the car much? and how long will the car last on just one of the bolts? thanks.
Posted: Fri Feb 01, 2008 11:14 pm
by CBR_TOY
just tweak it with a pry bar and it should work... i had to do it with my front end setup
Posted: Fri Feb 01, 2008 11:38 pm
by landslideATX
its bent at the end. i'm thinking about just getting new ones, after market. i'm looking at the t3 ones but i wanted to see if i can find them cheaper then $2oo. +shipping
Posted: Fri Mar 14, 2008 4:50 pm
by dr.occa
landslideATX wrote:its bent at the end. i'm thinking about just getting new ones, after market. i'm looking at the t3 ones but i wanted to see if i can find them cheaper then $2oo. +shipping
month old thread but LAW just picked up a set off of ebay. helped him install them. they looked pretty comparable to my T3s but A LOT cheaper. he likes 'em.