Page 1 of 1

Brake Noise

Posted: Mon Jan 17, 2011 10:41 pm
by CBR_TOY
first of all i need to rebuild just about everything on my car lol but,......

when i brake the damn things sound like air brakes. only when i'm going slow and coming to a stop or barely rolling not even on the brakes

weird. it's been doing it for a while and out of boredom i figured i'd ask about it here

it has like new rotors and used pads that have decent life

Re: Brake Noise

Posted: Mon Jan 17, 2011 11:06 pm
by daveskatesallday
hmm air brakes weird

have you taken the wheels off and looked in there on each corner?

Re: Brake Noise

Posted: Tue Jan 18, 2011 1:58 am
by CBR_TOY
nope ha ha

i'll have to one day

Re: Brake Noise

Posted: Tue Jan 18, 2011 2:39 am
by daveskatesallday
yea if i were you i'd take a good look you may find something

Re: Brake Noise

Posted: Tue Jan 18, 2011 4:25 am
by assassin10000
Check the clips that hold the brake pads in place.

Andrew

Re: Brake Noise

Posted: Tue Jan 18, 2011 6:35 pm
by mooreofit
what do airbrakes sound like. if its hardware it will squeel like a pig all the time.

Re: Brake Noise

Posted: Tue Jan 18, 2011 8:49 pm
by CBR_TOY
like when an 18 wheeler brakes and it has that rough sounding noise (not squealing)

Re: Brake Noise

Posted: Tue Jan 18, 2011 9:15 pm
by daveskatesallday
assassin10000 wrote:Check the clips that hold the brake pads in place.

Andrew
im missing some clips but don't hear that sound

Re: Brake Noise

Posted: Sat Jan 22, 2011 2:44 pm
by JDMwhiteboy
I have this same problem, its like a loud howling at low speeds? I know my proble is coming from the rear because this didnt appear till I did the GTS rear end swap and disk convert.

Re: Brake Noise

Posted: Sat Jan 22, 2011 11:24 pm
by CBR_TOY
i checked mine out and everything seemed fine

i think i need to cut my rotors and get new pads

Re: Brake Noise

Posted: Sat Jan 22, 2011 11:49 pm
by daveskatesallday
CBR_TOY wrote:i checked mine out and everything seemed fine

i think i need to cut my rotors and get new pads

checked the rears as well i assume?? now that i think about it my car used to do this but it was because the rears were pretty low it would make this noise as i reversed i didn't know what the hell it was i wouldn't even be applying the brakes and it would make this noise then i changed em out and it was all good

Re: Brake Noise

Posted: Sun Jan 23, 2011 10:51 am
by mooreofit
vibration squeel. lubricate pad mounting points and the back of the pad make sure the slide pins are lubed and cut the rotors. most places say you cant cut slotted drilled rotors on an amco but you can. dont forget to reface the pad if reusing.