www.86garage.com

16v start up problems with zenki harness help !!!!!

for anyone else reading this, heres abit more info. when we tried to start it, the fuel pump wouldnt turn on, so i jumped the fuel pump check connector, pump went on. tested the grounds leaving the AFM, nothing. made 2 leads connecting to the 2 AFM grounds and grounded them to the chassis, nothing...theres spark, but it still didnt start after jumping the connector and trying it. the intake mani ground is hooked up, and all grounds that were looked over seemed to be good, and all are there. looks like all plugs are in j/b#4(by the ecu), the relay box behind the drivers kick panel is good too. COR clicks, not 100% sure, but i think only when the check connector is jumped, leading me again, to think its the AFM. fuel pump relay is there...


im thinkin at this point ecu
suggestions????

the fuel pump relay is in the afm? the cor is the fuel pump relay in the ae101\92's

so its not getting fuel? is timing at 10*btdc during cranking?

A bad injector resistor box will cause them not to spray fuel into the engine. Spray starter fluid in the intake and see if it fires up. If it does then you know its fuel and can go from there.

sorry guys i got it turned on now i have no throttle response i was told if timing is off it would cause that so will see what happens once its set