Page 1 of 1
TE71/1UZ rear end questions
Posted: Thu Aug 09, 2012 6:16 pm
by chaddy
Alright well I have an 82 corolla coupe and I plan on doing a 1uz swap soon. I was wondering if anyone has done this and if so what rear end they used. I have seen the ae86 gts rear end, supra, and even some ford rear end swaps and would like to know what it would take for each rear end to work on my car. If any just bolt right up or what would have to be modded to work. When finished it will be a full track (drift) car that might see some street use but not much at all.
thanks
Re: TE71/1UZ rear end questions
Posted: Fri Aug 10, 2012 10:04 am
by bt20v
the factory corolla rear takes some beefing up to use...Weir axles and spool and people have still broken gears. The ford would be a good choice its strong and readily available...But wheel choice will be changed. I used a celica supra diff, made a jig, cut the mounts off the corolla diff, and had them welded to the celica supra diff. People have been running that diff with out problems. Its only 15mm wider then 86 gs diff and same bolt pattern.
T3 sells a kit that will allow that diff to be bolt in for an 86 I believe they are similar to yours but you would need to verify with T3
Re: TE71/1UZ rear end questions
Posted: Fri Aug 10, 2012 6:39 pm
by chaddy
Thanks a lot man that was very helpful. do you have any pics of your jig/ diff after welding?
Re: TE71/1UZ rear end questions
Posted: Sat Aug 11, 2012 12:18 am
by McKenney
You can get 4 links from t3 for the celica supra diff as well as a panhard. Then all you'll really need to swap is the spring perches. Save you alot of hassle.
Sent from my LG-MS690 using Tapatalk