www.86garage.com

saw this on club4ag it awsome i do have fiberglass knowledge an have made something i just get lazy and never with fiberglass project and dont finish but im gonna make the attempt to make and finish one set see how it turns out





day one of cup holder build pics still rough need to trim a bit more then clean it up and ready it so i can make first copy cup holder alot deeper then one orginally posted





yea i should be tryin to get my car turned on but im stuck waitin for harnesses to arrive so until then ill be workin on this

The 2 cup holder center console is a good idea. If I can suggest using the "Big Gulp" quickie mart cups for a mold. The bottom portion of them of course because they're designed to fit most if not all automotive cup holders. Looking forward to seeing your progress.

been done lol only one cup at a time though with big gulp

ohhh cupholder looks good

not done yea this just my mold still rough gotta clean it up

Question. Do you still intend to use the console for limited storage? The reason I ask is, if you mold a cupholder into the lid, will cupholder cradle be too deep to open the lid?

luisae86 wrote:been done lol only one cup at a time though with big gulp

Very cool there luis.

this is awesome.... i wouldn't mind having one of these

well its in works started makin first copy yesterday and hope to have the first rough copy by sunday at some point

GamblerZ wrote:Question. Do you still intend to use the console for limited storage? The reason I ask is, if you mold a cupholder into the lid, will cupholder cradle be too deep to open the lid?

no this will mainly jus be a couple holder no more lid it will have a bottom to it so if you wanted to toss loose change or anything else for that matter when not in cup holding mode you could do so, first pick of what im tryin to do that what im using for reference and also make it deeper than whats shown

luisae86 wrote:

"Cheeseburger Cheeseburger Cheeseburger Cheeseburger..."
[youtube]<object width="480" height="390"><param name="movie" value="http://www.youtube.com/v/hqsMmuQxYOs?fs ... ram><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/hqsMmuQxYOs?fs=1&hl=en_US" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="480" height="390"></embed></object>[/youtube]

lol good one

I want one!!! how much?

[quote="McKenney"]I want one!!! how much?[/quote

i would like to say im sorry for not updating this poat first off secondly i still have the mold but copies were never made due to funding my project car im almost dont with the car soon as its done i will put money back into this i have had several pple ask me for one so please be patient unless someone wants to take the idea an run with it and make it themselves it wouldnt bother me at all i would maybe even buy one off of u