Sakura Fab: W58/R154 to AE86 Transmission Mount

[McKenney]

They're a dime a dozen down here in Texas

[trajedy]

I'm finding they are about the same here in Georgia. :/

[JDM AE86]

Got one with your name on it..... well not technically

[trajedy]

I'd be glad to write my name across it.

[86boy]

why wasn't this released before I bought the Xcessive Manufacturing one.... -.-'


I also wouldn't say they are dime a dozen in Texas.... it took a few days to find one that wasn't $600+

[TeRRoR]

will this mount work without spacing the engine like most people do? for the 1uzfe swap i was not planning on using spacers for the subframe

[dr.occa]

will this mount work without spacing the engine like most people do? for the 1uzfe swap i was not planning on using spacers for the subframe

We'd be lying if we said we knew that it did. If you're talking about what I think you're talking about then if you don't add spacers between your cross member and chassis then your engine will just sit up higher which will in turn give you an idea of how your trans will line up using our mount. Please correct me if I'm not on the right track.

[TeRRoR]

will this mount work without spacing the engine like most people do? for the 1uzfe swap i was not planning on using spacers for the subframe

We'd be lying if we said we knew that it did. If you're talking about what I think you're talking about then if you don't add spacers between your cross member and chassis then your engine will just sit up higher which will in turn give you an idea of how your trans will line up using our mount. Please correct me if I'm not on the right track.

that is exactly what i am talking about, By the pictures that was posted the car using the tranny mount has crossmember spacers, is the mount made to be used with crossmember spacers?

[JDM AE86]

I'm running the same mount with out cross member spacers. But it will require a little hood work because it will sit up a little higher than the hood.

[JDM AE86]

Or you could get the custom cross member that drops 2 inches.

[TeRRoR]

any pics of your setup?

[McKenney]

If you want to see pics with spacers, check my build thread in the non native tech section under Toyota v6 & v8. I have a ton of pictures. The installed pic in this thread is on my car.

[TeRRoR]

i seen those pics, i wanted to see it without the spacers

[McKenney]

it will look the same at the trans cross member. dropping the motor 2" will only effect the angle of the front of the trans, and it's not something you'd really be able to distinguish without comparing the 2 different ones side to side.

[misterfx8]

i want one, pmed.