www.86garage.com

If you add up the cost of all the parts retail... there's $14k+ there....I know I won't get anywhere near that. I understand that just pointing that out. I need to get another car before I can actually sell this, but i figured I'd see if there was any interest in it first.

Feeler asking price $9,000 I have to have a

Engine:
4agze (DLI/MAP) with T3 timing gears
NST overdrive pullies
Mishimoto radiator and fans
Optima yellow top battery
Walbro 255 lph fuel pump
front mount intercooler
USPS oil cooler with stainless steel lines
OBX 16v header
OBX cat back OVER axle

Drivetrain:
ACT 6 puck unsprung disc (custom 200mm with w58 splines)
ACT Xtreme pressure plate
W58 transmission
Xcessive Trans mount
1 piece driveline custom to fit
WEIR spool and 30mm axles
WEIR 3.9 ring and pinion

Suspension
T3 tension control rods
T3 adjustable Lower Control Arms
T3 steering knuckles
T3 outer tie rods
MR2 manual rack with T3 bushing
BC Coilovers with BC RCA's
T3 4-link
T3 panhard bar
T3 Traction Control Brackets.

Wheels
XXR 002 wheels
XXR 530 wheels
Western Wheels Cyclone wheels.

Extras:
PLX wideband
Autometer water temp gauge
Autometer Oil Pressure gauge
20% tint all around
vinyl black out tail lights
NRG hub
NRG quick release
NRG steering wheel

I have the stock interior as its just not in the car. Body also has some rust and dents. Main damage is on the rear drivers side quarter panel

I bet with body work your price point could be realized. I still would love to feelher as is too. feelher all up and down

Yeah that's the downfall. I don't have the knowledge or the tools to learn bodywork. I have a couple things, but not enough to really do a whole lot.

nice hatch glws...........................

@dr.occa lock please