www.86garage.com

I bought this coupe for $200.00 in 2012.



So now I've started work on the AE86. I'm going to put the SR2ODET in my AE86. Today we started everything. I pulled the SR out and all the front suspension and cross member. Then installed the 240 front suspension and 240 cross member on the AE86. More to come as I get time.




AE86 front suspension and cross member.

240sx cross member installed on AE86

Full Megan Street from my 240sx Installed in the front.


Went ahead a set the SR20 in to make sure about any fab needed.


Went ahead and took the core support off and started pre making the tubs.








Pulled the SR20 out.
Pulled the windshield out.
Cut out the fender wells for tubs.
Pulled all the wiring out the AE86.









Ok I went ahead and remove the rear bumper and fuel tank. Removed the trunk lid and skinned it. Cut out the spare tire compartment. Also removed the rear end and finished cutting out the rest of the driver door.












Got my S&W 10 point roll cage in. Cage is 1 3/4 x .120 DOM. So I loaded the car up and drop it off at my buddy's place to be installed.





Roll cage is now being installed







2 more bars and then finish the X on the doors is all that left.

Looks good..

Wow, Awesome build man keep up the good work!

I like pic's! Plus Im interested on the s13 cross member, was it a direct bolt up?

Great build up so far. I was looking at the S & W roll cages too. Did it come with end plates?

Holy shit Im jealous....

The S13 cross member did not bolt in. I had to widen the holes. But for the most part it did. Has far as the S&W cage coming with plates. They do. I get my car back in a few day's. So I'll try and post some updated pictures.

RenoDrift wrote:...Has far as the S&W cage coming with plates. They do. I get my car back in a few day's. So I'll try and post some updated pictures.

Awesome. That's making the S&W cage looking more and more appealing for me. I'm looking at the DOM around the dash rather kit.

The S&W cage is worth it. I bought the 10 point 1 3/4 X .120 DOM. Got it over thanksgiving so the price was cheaper. About $534.00

Yeah that's hella cheap for a DOM 1.75" 10pt. Wish I had reached for it during the holidays.

Whoa, what a build. Noob question since you didn't mention it, but did the s13 engine k member and suspension just bolt right into the ae86 chassis? As in all the bolt holes and strut mounts lined up fine.

Ok got the the car back tonight. I hope the pic's are better.

cage looks good...

how is the cage fitment with the seat in place? Main hoop looks really far foward compared to what i have seen

Got a new turbo setup for SR86....