Leakin' Fluid?
- MadeInThe80s
- Member
- Posts: 688
- Joined: Wed Apr 15, 2009 3:45 am
- Location: Keller, Texas
- Contact:
Leakin' Fluid?
So Im leaking a little fluid near the rear diff where the u-joint is. Its not a bad leak but I have noticed some fluid on the ground around the drive shaft area there.
Any ideas what I should look at first? or is it something I should worry about at all?
Any ideas what I should look at first? or is it something I should worry about at all?
86 GTS 4AGTE
- MadeInThe80s
- Member
- Posts: 688
- Joined: Wed Apr 15, 2009 3:45 am
- Location: Keller, Texas
- Contact:
nope. its like 10 bucks you do have to pull the pinion shaft out just mark the jam nuts on the diff bearings pull the diff out and loosen the pinion nut and slide it out. then pop the seal.
when assembling you want to make sure that the diff has .008 thousands play from side to side and the pinion nut has 10 inch puonds of pre load.
when assembling you want to make sure that the diff has .008 thousands play from side to side and the pinion nut has 10 inch puonds of pre load.
[img]http://i300.photobucket.com/albums/nn17/mooreofalan/attachment-2-1-1-1-1.jpg[/img]
- MadeInThe80s
- Member
- Posts: 688
- Joined: Wed Apr 15, 2009 3:45 am
- Location: Keller, Texas
- Contact:
- MadeInThe80s
- Member
- Posts: 688
- Joined: Wed Apr 15, 2009 3:45 am
- Location: Keller, Texas
- Contact:
Car is here,
http://maps.google.com/maps?f=q&source= ... -97.112617
So its pretty far. Especially on an untuned car.
http://maps.google.com/maps?f=q&source= ... -97.112617
So its pretty far. Especially on an untuned car.
86 GTS 4AGTE
CBR_TOY wrote:i'm in the same boat... i need to do mine
(cbr)the offer stands for you too, im in the woodlands so it might make it easier for you!
(madeinthe80's) well maybe if im up there on the 19th for gymkana ill bring my seal puller and dial indicator we can wack it out then but i dont know if i'm gonna make it.
also have you tried the diyautotune base map for the 4age it got my 4afe started and the afr is pretty damn close too!
[img]http://i300.photobucket.com/albums/nn17/mooreofalan/attachment-2-1-1-1-1.jpg[/img]
- MadeInThe80s
- Member
- Posts: 688
- Joined: Wed Apr 15, 2009 3:45 am
- Location: Keller, Texas
- Contact:
i asume your tps based?
i dont remember do you have a wideband?
i havnt done mutch in the way of accell enrichment because of my tps problem but from what i gather the 4 load bins represent tps load points if its just a minor snap of the throttle you would go to the lowest bin and adjust the numbers up or down according to your wideband afr.
i dont remember do you have a wideband?
i havnt done mutch in the way of accell enrichment because of my tps problem but from what i gather the 4 load bins represent tps load points if its just a minor snap of the throttle you would go to the lowest bin and adjust the numbers up or down according to your wideband afr.
[img]http://i300.photobucket.com/albums/nn17/mooreofalan/attachment-2-1-1-1-1.jpg[/img]
You're not far from me... in the past you made it sound like it was pretty far out of the wayMadeInThe80s wrote:Car is here,
http://maps.google.com/maps?f=q&source= ... -97.112617
So its pretty far. Especially on an untuned car.
85 Hatch SR5 => GTS High Comp Levin!!!
84 Coupe SR5 => GTS JDM MAP 16V (My Wife's car!)
817.629.6119
84 Coupe SR5 => GTS JDM MAP 16V (My Wife's car!)
817.629.6119
- MadeInThe80s
- Member
- Posts: 688
- Joined: Wed Apr 15, 2009 3:45 am
- Location: Keller, Texas
- Contact: