My 86 Hachi coupe

[mooreofit]

you should be around 200whp at 10psi with a t25. 260 -280 whp around 20 psi. should be very interesting at 20 psi.

[MadeInThe80s]

Bored, so I thought Id update my status if anyone cares lol.

Water pump was leaking at the back seal that goes to the pipe under the manifold. It had a new seal on it so I thought maybe I didnt tighten it enough. Went to tighten it and snapped the stud right off. Sooooooo, Im waiting on a new pump to come in and just replace the whole thing and not worry about it again. It gets here Tuesday and I'll get it put on some day this coming week. Ive already primed the motor/turbo with oil and everything seems to be working great. As soon as the new pump goes on and I get the downpipe rewelded up I'll crank it up and check for any other shake down issues. My exhaust will probably get here around the beginning of March hopefully so then I can get that on and start driving it around to get the rings and everything seated in good. Then if all goes well, I might actually make the Austin meet, but thats a whole other subject in itself.

[MadeInThe80s]

Since it was raining I did some inside work today
Supra meet Corolla:

[nt66]

just a for warning my car with a t25 that was further away from the brake booster would boild brake fluid after like 3 back to back runs. I would have total brake loss and would have to fight to get it stopped. Heat shields will help but it will stil happen if you beat on it for any amount of time that's one of the reasons why I went reverse pedal mount setup

[MadeInThe80s]

Reverse pedal mount?

Ive got to put some heat wrap and stuff on there like you said as well. I have a line in there that needs covering up too. Did you run the water lines on it as well?

[mooreofit]

http://www.pegasusautoracing.com/bigpic ... RecID=4594" onclick="window.open(this.href);return false;

i will own these one day!^^


http://www.wilwood.com/Products/005-Ped ... dal-As.jpg" onclick="window.open(this.href);return false;

[MadeInThe80s]

WoW! Thats way different. Is there room under the stock dash for all that? Im assuming pure racing application.

[mooreofit]

the floor mount setup would need some floor pan work. also if you keep most of the stock dash i dont know if the reverse mount would work. will might now. but i think his dash is pretty bare on the other side.

[nt66]

WoW! Thats way different. Is there room under the stock dash for all that? Im assuming pure racing application.

I'm running most of the dash but my dash bar is part of the roll cage I don't think it will work with the stock dash bar. My car with a double layer (steel/aluminum) heat shield, gold foil stuff, and that silver heat wrap stuff still boiled the bake fluid all the time and my turbo was a LOT further away from the master then yours so be prepared.

[MadeInThe80s]

Haha.
http://www.youtube.com/watch?v=BdEbOIwVCsA" onclick="window.open(this.href);return false;

[MadeInThe80s]

http://www.youtube.com/watch?v=1pJgBrxSPtc" onclick="window.open(this.href);return false;

[dfi1120]

NICE REALLY NICE

[MadeInThe80s]

No exhaust, no downpipe lol

[MadeInThe80s]

Motor is running good, drive shaft is getting made up, down-pipe will soon be installed and exhaust will be here sometime next month. Its almost back to drivable status again!

[td-civ]

looking good