My 86 Hachi coupe

[mooreofit]

where did you get the downpipe?

[MadeInThe80s]

Its the downpipe that the kit came with.

[MadeInThe80s]

Well,
Started the car up today, let it run for a bit, turned it off.

Walked away, looked back to see a small puddle of oil underneath the car. BAH!

Took a second to trace it down and apparently the mechanical oil line
has a small pinhole in it somehow and was squirting a small stream of
oil onto the block. Wasnt there yesterday when I ran it. I dont
understand how a plastic tube all of a sudden gets a hole in it like
that.

[STLove]

look into some ss lines... i picked up some from summet, 10ft for 30 something..

[MadeInThe80s]

Put her back on the ground today after installing driveshaft and tranny fluid then drove it around the block to see how the car felt. The 5 puck clutch ACT HD pressure plate and W58 feel fantastic! Transmission shifts like butter and the clutch pedal feel isnt too much to handle. Now I need to button up a few loose ends and then get it tuned up. I didnt take it past 4k and it seemed to want to bog down a bit occasionally, but Im assuming its partly due to a couple things that need to be tweaked and finished up.

14.8 lbs

[STLove]

might wana check your fuel pressure....

is that Drive shaft still up for sale?

[MadeInThe80s]

Driveshaft is sold. Im working on getting a fuel pressure gauge so I can adjust it. I also need to switch the fuel pump out to a larger unit.

[STLove]

damn.. that this was SEXY!!!

[td-civ]

nice shaft i like

[mooreofit]

do you have a wideband? if not it should be on the list. what kind of fuel map additions have been made since the turbo was installed?also whats the timing at wot? i would run 17 to 20 ish degrees of advance at wot until you have some sort of knock detection theres a couple good aftermarket units available but a set of det cans works the best.

[MadeInThe80s]

440 cc injectors
Adjustable FPR
Walbro pump

The map is a 440cc map from diyautotune.com running the same setup as me. I have had a wideband ever since I started my megasquirt. I also have a knock sensor I need to get installed as well. Im going to get it running 95% ok then take it to the dyno for real tuning.

[MadeInThe80s]

I finally have something new to post. Got my exhaust in finally and hopefully got my wideband issue solved. Just gotta pick up my downpipe and get them installed.

[joel26]

very nice muffler...........

[mooreofit]

nice exhaust. got a question, what tire size you running?

[MadeInThe80s]

I think 225's. Its been awhile so I dont remember exactly.