1992 240SX SE:
Engine/Drivetrain
-248/248 cams with intake cam advanced 5*
-Trust Gracer Airinx filter
-Drift Freaq Custom Urethane Engine Mounts
-Peak Performance Pro Transmission Mount
Suspension/Steering
(Front)
-Stealth Fab Front Strut Tower Brace
-Stealth Fab Rear Strut Tower Brace
-Stealth Fab Tension Rod Brace
-New front control arms with new bushings/ball joints
-Energy Suspension Steering Rack bushings
-Energy Suspension Sway Bar Bushings/End-link bushings
-SPL Tension Rods
-Aluminum Steering Bushing
(Rear)
-Progress Sway Bar
-RPSports Subframe Stiffeners
Exterior
-Cibie E-Code H4 Headlight Housings
132,XXX miles on it. The owners said it hesitated and was making a bad rattling noise from the front of the engine. I test drove it and verified it. The hesitation was due to a bad alternator and cheap plug wires. At mid to high RPMs the battery couldn't sustain the charge system and would drop power and there was no juice for spark. So a new alternator and battery later and she runs perfect. The plug wires themselves just didn't fit. The base of the boot was too large. It would compress when installed and during driving it would expand to it's normal length, disconnecting the plug wire from the spark plug in the process.
The rattle was also easily fixed. The top chain guide had broke and was bouncing on top of the chain. I removed that and the driver-side upper guide and she has a really quiet engine now.
So this weekend I swapped out the stock tension rods with a set from SPL. While I was under there I noticed the rack boots were torn and the tie rods were all tired and sloppy so I ended up getting some replacements from Autozone. Got everything installed, set the alignment and everything feels much better now. I didn't get too many pics of the tie rod swap. It was too damn hot and I wasn't in the mood to be taking pictures by the time I got to it.
