FS/FT: 4A-C and SR-5 parts

Moderators: dr.occa, CBR_TOY

Post Reply
Force_Fed
Member
Posts: 160
Joined: Wed Jun 02, 2010 1:17 am
Location: SW Houston, Texas

FS/FT: 4A-C and SR-5 parts

Post by Force_Fed »

OK guys. here are a few things for sale or trade. Most of these prices are firm because they're not rediculously expensive. If they were, they'd never sell and I'd be sitting on them for like 5 years or something. ;) If you do not agree with a posted price, PM me and we'll discuss. I am willing to ship, so if needed, post or PM me your zip so I can get a shipping quote. I am located in the Sugar Land area which is considered SW Houston so some of you can come get this stuff... :)

Also, before this gets out of hand, I will NOT deliver or meet up with you for your $5 part you just purchased. I can deliver or meet up (if my schedule allows) but fuel expense needs to be taken into consideration, please. Also, these prices are for pick-up ONLY. Like stated above, you want shipped, PM me and we'll work it out.

$40 - 4A-C SOHC head (complete) and valve cover
Image
Image

$25 - 3-rib 4A-C short block. Cylinders #3 and #4 are saturated with rust and was partially seized. Was a bugger to loosen. This engine had been running before and was ran fine. The engine was left outside to the elements with the carb uncovered...
Image
Image
Image

$20 - 4A-C distributor, rotor, cap and wires
Image

$5 - 4A-C A/T flexplate.
Image

$10 - Air duct - Heater core section. Heater core has a broken pipe so it needs to be replaced. All registers are functional. Tested it prior to disassembly of the car. Heater section is on the left.
$25 - Blower fan assembly. Blower worked great in all speeds so that means the motor and resistor are functional. Tested it prior to disassembly of the car. Blower section is the one on the right. Also have the blower switch for $10

Image

$5 - OEM Struts and OEM rear springs. Strut condition unknown
Image

$10 - SR-5 fuel tank. Based on opacity and smell of drained fuel, a seasoned guess would be that the fuel was at least 3 years old or very dirty. Inner wall condition is unknown.
Image

$5 - SR-5 coolant reservoir and washer reservoir w/ motor.
Image

$25 - Starter
$40 - Alternator
or $50 for both.

SR-5 alternator and starter. Just tested both of these a week or so ago, and both work just fine. Starter amperage draw is within spec and alternator output is satisfactory.
Image

$50 - Complete rear seats for a coupe. Backs are actually in very good condition. Latches work great and upholstery is intact. NO TEARS. The bottom is a tad bit dirty but I'm pretty sure that's from the previous owner that had miscellaneous parts on it. I'll clean it up tomorrow or sometime soon. Seat belt clasps (inner), retractor assemblies (outer), brackets, strikers and all hardware are included. I'll probably throw in extra panels you may need.
Image
Image
Image

For any questions that may arise, I can be reached at (832) 451.4949, via PM, or via post. If there's anything else you might need, get in touch with me.

Thank you for looking,
- Frank
Last edited by Force_Fed on Fri Jul 02, 2010 10:39 pm, edited 3 times in total.

Force_Fed
Member
Posts: 160
Joined: Wed Jun 02, 2010 1:17 am
Location: SW Houston, Texas

Re: FS/FT: 4A-C and A/T

Post by Force_Fed »

Anybody need singular parts. I'm thinking of selling in pieces since there seems to be no interest for this as a whole assembly.

Force_Fed
Member
Posts: 160
Joined: Wed Jun 02, 2010 1:17 am
Location: SW Houston, Texas

Re: FS/FT: 4A-C and A/T

Post by Force_Fed »

Engine has been disassembled and is seperated from the tranny. Will edit first post with new info.

a.k.a.vene
Member
Posts: 436
Joined: Sat Jul 18, 2009 6:11 pm
Location: h-town

Re: FS/FT: 4A-C and A/T

Post by a.k.a.vene »

i will buy u the wire harness from the sr5 engine bay(i need the altenator plug wires)
TILL IT REDLINES HACHI!!!!!!!!
NONSTOPTUNING.COM

TEAMSUNWORKS.COM


Force_Fed
Member
Posts: 160
Joined: Wed Jun 02, 2010 1:17 am
Location: SW Houston, Texas

Re: FS/FT: 4A-C and SR-5 parts

Post by Force_Fed »

Parts list updated with pics

DjSpecter
Member
Posts: 848
Joined: Tue Jan 27, 2009 1:53 am
Location: San Antonio
Contact:

Re: FS/FT: 4A-C and SR-5 parts

Post by DjSpecter »

PM sent
Only on the internet could a man spend a lot of time and effort doing a high quality job only to have everyone rip him a new hole for not having the same exact taste as everyone else.

ø„¸¨°º¤ø„¸¸„ø¤º°¨¸„ø¤º°¨
¨°º¤ø HARD TRANCE ø¤º°¨
„ø¤º° FOREVER °º¤ø

Force_Fed
Member
Posts: 160
Joined: Wed Jun 02, 2010 1:17 am
Location: SW Houston, Texas

Re: FS/FT: 4A-C and SR-5 parts

Post by Force_Fed »

Head and struts pending...

Post Reply