4AGZE

[McKenney]

I have an 87 GTS with the funky Red top TVIS motor. Scored a complete GZE setup minus harness. I have the ecu and all sensors though. I'm going rhd and have the complete 87 Levin GTV car harness. The pinouts are the same(14,18,10) What all is different between the ecus? If I can run my stock harness just swap some pinouts I might go that way and just eliminate the need for a harness. The only thing I can see being needed would be the part of the harness that runs the sc relay. But I'm probably going to run it on a toggle switch. Lemme know.

[McKenney]

Spent an hour on the phone with Jonas last night and have decided which route I'm going. Thanks for your time Jonas and look forward to getting this all done and in the car.

And for the people who don't know him, Jonas is an extremely nice and knowledgable and would recommend him for all your wiring needs and questions. Thanks again man!

[joel26]

Spent an hour on the phone with Jonas last night and have decided which route I'm going. Thanks for your time Jonas and look forward to getting this all done and in the car.

And for the people who don't know him, Jonas is an extremely nice and knowledgable and would recommend him for all your wiring needs and questions. Thanks again man!

I second that he is a cool cat.....

[fivehunsky]

here you go

[McKenney]

Awesome man! Thanks!!! Bytheway you have the stock AE86 maf.

[McKenney]

I was on the phone with my guy at Toyota when I noticed the post and had him check it. So that car is running a stock maf.

[fivehunsky]

haha.. cool.. I thought so but I didnt want to say for sure and screw you over

[dr.occa]

I appreciate the kind words guys. Hey McKenney, I think you need an "fsm"....

[McKenney]

Full Service Manual?

[dr.occa]

[McKenney]

Righteous!!!!