my built 20v blacktop

[supra_750]

Yep toda 304 with 9mm lift

[mooreofit]

it sounds sexy. thats a big cam with the setup to match. should pull hard. whats the comp ratio?

[supra_750]

total i belive to be about 13 - 1. waiting on 1 shim then the motor is back together for tuning

[supra_750]

and heres a teaser

[joel26]

looks good......

[daveskatesallday]

oh the angle

[mooreofit]

wow should bake close to to 200whp.

should be a :weapons36:

[16vHachi]

Oh gawd.....

[CBR_TOY]

holy damn angle!!!! i need this

any binding issues?

alignment specs?

[supra_750]

havnt got it aligned yet kinda did it by eye and measuring to get them the same. have the lcas a little more than half an inch longer and still rub inner fender and hits the tension rod the other , got that worked out had a slight toe in. all t3 stuff with manuel rack and nst spacer.

[supra_750]

well just got done swapping the cams out and re shimming the motor for the stock cams...... IM GOIN TO DALLAS DAMNITTTTT hopefully (: sux no crazy loping cams and big power but ima be there!!! with a fully built bottom end 13-1 and stock cams like a G. for all those that dont know something happend to the intake cam to wear extreammmmly bad and was causing the "tick" which we belive to be from opening the valve super harsh.... ahh gotta love last minute problems.

[CBR_TOY]

sucks to hear man.... i hope you get some more lumpy cams in her

it sounded hot

[mooreofit]

that really sucks. you could probably save the cam and have it re ground.

[bt20v]

how its all going??

[supra_750]

ummm prolly gunna start a forsale thread soon