Feeler thread: 4AGZE

[McKenney]

I have a rebuilt 3 rib bluetop(all new gaskets, rings, bearings, valve stem seals, timing belt and tensioner, new timing belt crank drive gear, harmonic balancer and key, water pump, 20V water pump outlet, and oil pump). Just finished assembly on Sunday May 15th. On to the fun side, complete ZE(USDM) intake and SC12 assembly with new gaskets. Assembled! I will try and post pics asap. Dr. Occa is building the harness as we speak and will be included in the deal if I sell it. I have the ecu and a front mount intercooler from a BMW 535i turbo capable of supporting 500+ hp. This is a 9.4:1 motor and with the current crank pulley would be pushing 4-5 psi. Was only gonna use this pulley for break-in then step up to the NST big pulley kit. Which if my math is right(and it usually is), small pulley would be around 150hp and the NST one would be around 200hp. I have a GTS flywheel and clutch assembly(used) and a complete GTS transmission that might go with it for the right price. I have well over $1500 in this swap and now I'm borderline on needing to sell it. You will need ic piping and a starter and alternator and fan assembly as I don't have spares. I'm working on the upper water outlet and remote thermostat setup right now. They both will come with the setup. Serious inquiries only please. I will NOT ship due to it being heavy as hell! My cell is (972)704-6004, have good pics on phone and can take more upon request. I'm located in Garland(north Dallas). Thanks for looking.

McKenney


Trades considered

[McKenney]

Injectors, fuel rail, damper and regulator all included as well. I even have a ZE distributor.

[McKenney]

The inlet side of the intake isn't bolted on in these pics. And no, the header is not included. I also have a brand new in package Denso oxygen sensor specific for the 4AGZE.

[McKenney]

The GTS oil filter adapter isn't on in the pic but I do have it and it will be installed before pick up. The fram filter is only on there to keep junk out of the block...

[McKenney]

Asking $2000 with trans and flywheel or $1500 without. Am open to separating the ZE stuff and the bluetop stuff. I have a bluetop harness and intake as well. Currently the bluetop harness is spoken for by c4ptiv3, but if he bails, the harness will be for sale.

[McKenney]

Looking for coilovers... used in good condition is fine with me.

[JDM AE86]

hmmmmm

[McKenney]

hmmmmm what??

[McKenney]

All ze accessories and harness are sold. Lock thread please