Just now joining 86garage.com

[AE86Taylor]

thanks. I need to post up. i've run into a few assembly questions on my MS2. I'm also using EDIS.

[mooreofit]

i paid diyautotune to assemble mine.

[AE86Taylor]

I got mine from them. but I'm on a very tight budget. I got the ecu about done, all thats left is some wiring and some fuel stuff.

[mooreofit]

i will build my next one but im still not comfortable with my soldering skills on a circuit board. especially crossing circuits with splatter and such.wirings pretty easy. what are you running for ignition input? i suggest staying away from a strait vr sensor to the ms. i had huge noise issues that held me up for months. still had the issue when i pulled it off my car. im now going to edis as it has better built in noise protection than the ms. the 5v square wave is the best ignition input in my opinion. good luck with the install and tuning is really fun and rewarding.

[AE86Taylor]

I have EDIS now. I planned it from the get go but could never find a machine shop to mount the trigger wheel on the crank pulley. Finally met a guy through one of my wifes friends, who is a machinist. A beer and a two day wait, and I had a mounted and TIG welded trigger wheel. The new ZEAL board DIY sells, takes care of the signal noise on the stock VR sensor. but since i am missing alot of the stock stuff, and already have EDIS i am just going to roll with it. I've been waiting years to get it done, and over a year and a half my car has been down.

[mooreofit]

i know the feeling. i have had my 86 for almost three years and have driven it for less than 5mins.

by the way nst will mount a trigger wheel to there crank pulleys for little extra.i have one and ill have pics up soon.

[AE86Taylor]

Yea, if i have problems with my trigger wheel I will seek an alternative. I'll have to post up pics of my builds so you can check out my harness mod. It comes in handy and cuts down on the removal time of the engine.