www.86garage.com

choi0706 · Post by **choi0706** » Sun Aug 24, 2008 4:13 pm

Hi....

I bought NST Mike's old mr2..

hvguy · Post by **hvguy** » Sun Aug 24, 2008 4:57 pm

Welcome!

Pics of the Mr.??

Post by **dr.occa** » Sun Aug 24, 2008 5:03 pm

welcome choi. glad to have you aboard.

Post by **nt66** » Sun Aug 24, 2008 5:51 pm

that mr2 was nice what are your plans for it

Post by **CBR_TOY** » Sun Aug 24, 2008 6:32 pm

welcome..... you bought the gray one right?

Nasser · Post by **Nasser** » Sun Aug 24, 2008 8:51 pm

welcome, my names Nasser the kid with the red 86.

choi0706 · Post by **choi0706** » Sun Aug 24, 2008 9:54 pm

no pics.. it hasnt changed since mike had it.. I have a huge ton of parts to put in..

Full engine rebuild/full coatings from polydyn blacktop20V

C60 6spd with custom short ratio. upgraded gearset and synchros (Fidanza 3.2 clutch/fidanza flywheel)

HKS header/downpipe

Custom Air Intake setup

Gold heat barrier

Custom Oiling system (accusump/welded pan/remote Chevy racing filter/cooler with fan/SS lines)

All new suspension overhaul,(eibach springs/every single bushing replaced to polyurethane/new endlinks with sperical bearings/new wheel bearings/ shitty tockico struts/// ohlin setup later)

New brakes (OE spec, will upgrade to wilwood calipers and 2piece floating rotors later)

Probably a bit more that I cant think of.. But will update this post if I remember later..

pecx · Post by **pecx** » Sun Aug 24, 2008 11:02 pm

Welcome aboard. Cant wait to see the finish project. (^_^)

choi0706 · Post by **choi0706** » Sun Aug 24, 2008 11:05 pm

anyone have a empty trailer thats going to austin?I need to tow my mr2 to austin..

Ricky86 · Post by **Ricky86** » Mon Aug 25, 2008 8:44 am

Sup Jay, post pics

.

choi0706 · Post by **choi0706** » Mon Aug 25, 2008 8:36 pm

some pics

Finally picked up my parts from polydyn..

choi0706 · Post by **choi0706** » Mon Aug 25, 2008 8:38 pm

Big thanks to Austin Cylinder Head.. They're doing an EXCELLENT job with rebuilding my 20v..

http://austincylinderhead.com/

Post by **CBR_TOY** » Mon Aug 25, 2008 8:59 pm

wow! very nice looking parts/motor!

hvguy · Post by **hvguy** » Mon Aug 25, 2008 11:14 pm

OH my god! Thats a huge valve spring compressor. Where did you find such a tool?

choi0706 · Post by **choi0706** » Mon Aug 25, 2008 11:17 pm

not mine.. it's a picture from the machine shop, (austincylinderhead)

they have lots of experience with 4age(s) and they also have the equipment to do multiangle valves, and valve seats with precision CNC..